5
GENERAL OPERATING INSTRUCTIONS
1. Check the Wheel operation by slowly pulling the Hose out. You should hear a
clicking noise.
2. To lock the Hose, pull it out a minimum of 1/2 revolution and it will stay locked
after the first, second, or third click.
3. To unlock, slowly pull until the clicking stops, and let it retract until the Hose
Stopper hits the Hose Guide.
CAUTION
• Hold on to the Hose while it is rewinding, to avoid damage to the Hose Reel.
4. Attach a coupler (sold separately) to your air compressor hose and apply
thread seal tape to the Inlet fitting on the Reel. Connect the coupler to the Inlet
fitting.
5. Connect your air tool to the other end of the Hose using another coupler
and thread seal tape.
6. Follow all instructions from the air tool and compressor for set up and use.
7. When finished using the Hose, disconnect the air tool and retract the hose.
Wipe the Hose Reel clean with a dry cloth.
MAINTENANCE
WARNING
• To prevent serious injury :
Detach air supply from this product before performing any inspection,
maintenance, or cleaning procedures.
• To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise, vibration, or leaking air
occurs, have the problem corrected before further use.
CLEANING, MAINTENANCE, AND LUBRICATION
NOTICE
• These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the Hose Reel.
1. BEFORE EACH USE, inspect the general condition of the tool. Check for:
• loose hardware or housing,
• misalignment or binding of moving parts,
• cracked or broken parts, and any other condition that may affect its safe