TO START BLASTING
NOTE:
Start with all valves in the closed position. Following the instructions
below will help prevent clogging in the delivery hose, outlet
manifold and the safety trigger.
1.
2.
Fig
8
Connect compressor to the inlet connector.
Start compressor and open the air
supply valve, see Fig
8
.
• The tank will start to pressurise.
3.
Fig
9
Test the safety valve by pulling
up on the valve as shown in Fig
9
.
• Air will hiss out when the valve is
pulled.
4.
Open the throttle valve, Fig 1
0
.
5.
Check for leaks at the filler cap
and along all hoses and fittings as
the system pressurises. If leaks are
observed, release the pressure
from the tank and repair leaks
immediately.
6.
7.
Fig
11
Press and hold the safety trigger
until air is flowing through it.
With the safety trigger open,
slowly open the abrasive control
valve and shown in Fig 1
1
until
abrasive material begins to flow
out of the safety trigger.
8. Adjust the abrasive control valve
until the desired amount of
abrasive material is flowing
through the safety trigger,
9. Begin blasting.
Fig 1
0
11
