5
OPERATION
ATTACHING SANDPAPER
Note: Sandpaper is not included.
Note: The Sander must be disconnected from the air hose before attaching sandpaper.
1. Push down on the Clamp Lever and it will release the Paper Clamp. See FIGURE 1.
2. Insert one end of the sandpaper under the Paper Clamp and snap it closed. Repeat he
process with the rear Paper Clamp.
FIGURE 1
3. Check that the sandpaper fits snugly against the Sanding Pad. If not, repeat the process
above and pull the sandpaper more tightly against the Sanding Pad.
4. Connect the sander to the air compressor.
5. Set the compressor to 90 PSI. Do not exceed 100 PSI.
6. If applicable, secure your workpiece. Use appropriate clamping devices if applicable.
7. Before starting the Sander, place it on the workpiece. If you start the
Sander before you contact the workpiece, the Sander may vibrate out
of your hand once you contact the workpiece.
8. To operate, press the Lever with the palm of your hand while using your fingers to grasp
the Sander. See FIGURE 1. The further you press down on the Lever, the faster the
Sander will rotate. For fine tuning the air pressure, adjust the Regulator Knob.
9. Do not apply force or pressure. Allow the Sander to do the work for you.
Note: During operation, use your other hand to keep the air hose clear of the Sander.
10. When finished, release the Lever and disconnect the air hose from the Sander.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities.
Please work in a well ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles.
TECHNICAL D
AT
A
Model
CT0879
Air pressure
6.0 bar
Free speed
8000rpm
Avg. air consumption
171 l/min
Air inlet size
1/4”
Hose size
3/8”
