Neilsen CT0721, Инструкция по эксплуатации, Страница: 6 / 21

SPECIFIC SAFETY RULES – cont’d
ƒ
TO AVOID INJURY
from accidental
starting, always remove the Plug from the
electrical socket before installing or
removing a drill or chisel bit.
ƒ
When using SDS drill only use bits that
are configured with the correct slots for
SDS chucks.
ƒ
BEFORE STARTING
the operation, jog the
drill switch to make sure the drill bit does
not wobble or vibrate.
ƒ
DO NOT USE
fly cutters or multiple-part
hole cutters, as they can come apart or
become unbalanced in use.
ƒ
MAKE SURE
the spindle has come to a
complete stop before touching the SDS
chuck or attempting to change the drill bit
also beware that the bit will be hot, let it
cool down before changing as it could burn
and cause injury .
ƒ
ALWAYS MAKE SURE THE DRILL OR
CHISEL IS FIRMLY SEATED IN THE SDS
CHUCK
before starting the drill.
Some of the following symbols may be used
on your tool. Please study them and learn
their meaning. Proper interpretation of these
symbols will allow you to operate the tool
better and safer.
V
volts
A
amperes
Hz
hertz
W
watt
Kw
kilowatts
F
farads
microfarads
l
litres
Kg
kilograms
bar
bars
Pa
pascals
h
Hours
min
minutes
s
seconds
No load speed
./min or min¯¹
Revolutions or
reciprocations per minute
direct current
alternating current
²
two-phase alternating
current
2N
two-phase alternating
current with neutral
three-phase alternating
current
3N
three-phase alternating
current with neutral
Rated current of the
appropriate fuse-link in
amperes
Time-lag miniature fuse-
link where X is the symbol
for the time/current
characteristic, as given in
EN 60127
protective earthing at
earthing terminal, Class I
tools
Diameter
Off position
Arrow
Warning symbol
alternating or direct current
splash proof construction
watertight construction
class II construction
IPXX
IP symbol
Hammer symbol
Drill symbol
POWER TOOL SAFETY
DRILL SAFETY
6
SYMBOLS