Neilsen CT0346, Оригинальное руководство пользователя

Страница: 8 / 12

Hoist Capacity Replace hook when the opening is greater than
1000kgs 28.6mm
2000kgs 38.5mm
GAUGING LOAD CHAIN WEAR (Fig.3.):
To determine if the load chain should continue to
Be used. Check the gauge lengths as shown. Chain
wornbeyond length indicated, severely nicked,
gouged or twisted should be replaced before using
the chain block again. Both chains should be cleaned,
free of twists and pulled taut before measuring. In
cases where the wear is localized and not beyond
serviceable limits, the chain should be replaced.
HAND CHAIN:
The hand chain should be cleaned, inspected and gauged in the same manner as the load
chain. The hand chain does contain an un-welded link. Therefore, if it is necessary to
shorten the hand chain or replace the hand chain, a hand chain connecting link will be
required. Note, opening and closing the connecting link more than twice is not
recommended. Also, connecting links must not be made by cutting the weld side of a
standard hand chain link. Care must be taken to ensure that there is no twists in the hand
chain loop.
LUBRICATION:
Lubricate the load chain with a light coating of chain oil. Be sure the lubricant reaches the
bearing surfaces between the links, remove the excess oil from the chain using a cloth.
WARNING:
The brake is designed to operate dry. Do not use any grease or lubricant on the braking
surfaces. When lubricating pans adjacent to the brake, do not use excessive amount of
lubricant, which could seep onto the brake surfaces.