en
operation
34
13.8 Starting the programme
Requirement:
A programme has
been set.
→
"Setting a programme", Page 32
▶
Press
Start/Reload
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.The display shows either the
programme duration or the "Ready
in" time.
a
After the programme has ended,
the display shows:
End
.
13.9 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡
The programme is set.
→
"Setting a programme", Page 32
¡
The "Ready in" time is set and ac-
tivated.
→
1.
Press
Start/Reload
.
The activated "Ready in" time is
paused.
2.
Press
Finished in
repeatedly until
the display indicates the desired
"Ready in" time.
3.
Press
Start/Reload
.
The changed "Ready in" time is ac-
tivated.
13.10 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Start/Re-
load
.
3.
To resume the programme, after
the desired soaking time, press
Start/Reload
.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
1.
Press
Start/Reload
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/Reload
.
13.12 Cancelling the pro-
gramme
1.
Press
Start/Reload
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
