NEFF T62R36 series, Инструкция по эксплуатации

Страница: 6 / 17

6
Safety system
All the hotplates have a security device (thermocouple).
If the burner is switched off during operation (e.g. due to a
draught), the appliance automatically switches on the hotplate
again.
If reignition is not successful (e.g. due to food remains on the
burner), the supply of gas to this burner is cut off and the
burner hotplate indicator flashes. Turn the control knob to 0
and check the section on Operating indicators and error
messages .
Switching off a burner
Turn the corresponding control knob clockwise to the 0 setting.
Automatic off
After six hours of operation, the appliance switches off
automatically. Turn all control knobs to setting 0; the appliance
can now be switched on again.
Power levels
The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Protection against overheating
The hob has a protection against overheating system to protect
the electrical installation. This switches off all the burners in
case of overheating and the operating indicators start to flicker.
Turn all control knobs to setting 0. Wait until the appliance has
cooled down sufficiently. Now you can reconnect the appliance
normally. The rapid flickering of the burner operation indicators
switches off or is replaced by the residual heat indicator.
Warnings
This appliance will not function if it is not connected to the
mains or if the electricity supply is cut off.
It is normal to hear a soft whistling noise while the burner is
operating.
When first used, it is normal for the burner to give off odours.
This does not pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the
presence of dust in the atmosphere, spilt liquids, etc.
A few seconds after the burner is switched off, a sound (thud)
will be produced. This is not a fault - this means that the safety
device is no longer operating.
Keep the burner as clean as possible. If the ignition sparkers
are dirty they will not light properly. Clean them periodically
using a small non-wire brush. Bear in mind that the ignition
sparkers must not suffer any serious impacts.
Cooking guidelines
Operating indicators and error messages
Setting Ú Control knob off
High flame › Maximum capacity or aperture and elec-
tricity on
Low flame
œ
Minimum capacity or aperture
LJQLWLRQVSDUNHU WKHUPRFRXSOH
Burner Very high - High Medium Low
Wok burner Boiling, steam-
ing, griddling,
toasting, paellas,
Asian food (wok).
Reheating and keeping
things hot: cooked and pre-
cooked dishes
Rapid burner Escalopes,
steaks, ome-
lettes, frying
Rice, white
sauce, ragout
Steaming:
fish, vegeta-
bles
Semi-rapid
burner
Steamed pota-
toes, fresh vege-
tables, vegetable
stews, pasta
Reheating, keeping things
hot and making tasty casse-
roles
Auxiliary
burner
Cooking: casse-
roles, rice pud-
ding, caramel
Defrosting
and slow
cooking: veg-
etables, fruit
and frozen
products
Melting: but-
ter, choco-
late, jelly
Operation indicators Indication Meaning
The operation indicators are on. All the burners are switched on or are still hot.
A burner indicator lights up. The burner is switched on or is still hot.