NEFF S717P80X1E, Инструкция по эксплуатации

Страница: 17 / 52

Rinse aid
en
17
Top up the rinse-aid as follows:
1.
Open dispenser
92
; press lug on
the lid (1) and lift (2).
2.
Add rinse-aid up to the max. mark.
3.
Close the lid.
Lid “clicks” into position.
4.
Remove overflowed rinse aid with a
cloth.
This prevents excessive frothing
during the next rinse cycle.
Setting amount of rinse aid
The amount of rinse aid to be
dispensed can be set from
0
to
6
. Set
the amount of rinse aid to be dispensed
to
5
to obtain a very good drying result.
Do not change the amount of rinse aid
unless there are streaks or water stains
on the utensils. Set a lower level to
avoid streaks. Set a higher level to
avoid water stains.
Set the amount of rinse aid as follows:
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Press Info button
{ 8
for 3
seconds until the following text is
indicated on the display window at
the top
@
:
Scroll with
< >
Set with
- +
Leave with Setup 3 sec.
4.
Keep pressing button
>
)*
until the
rinse aid dispenser is indicated on
the display window at the top
@
.
5.
Make the setting with setting buttons
+ -
X
.
6.
Press and hold the Info button
{
8
for 3 seconds.
The chosen setting has now been
stored.
Switching off rinse aid refill
indicator
If the use of combined detergents with a
rinse-aid component impairs the low
rinse-aid indicator
H
on the control
panel or the text on the front
display *
):
(enough rinse aid for x
rinse cycles), the displays can be
switched off.
Proceed as described under “Setting
amount of rinse aid” and select
setting
0
.
* depending on the features of your
dishwasher
PD[