NEFF R8580X2GB, Инструкция по установке и эксплуатации

Страница: 23 / 32

Faults and what to do about them
en
23
3
Faults and what to do about them
Faults and what to do about them
Faults Cause/remedy
ð
in the display panel
and drying has been
interrupted.
■
Empty the condensate container;
~
Page 19 and the dryer;
~
Page 29 .
■
If the optional condensation drain is installed, the drain hose may be
blocked. Check the hose for deposits and flush the hose out.
é
in the display panel. Clean the fluff filter and/or the heat exchanger, then select the Start button
~
Page 18 ;
~
Page 21 .
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the child-proof lock.
■
"Ready in" time selected? Programme starts after a delay.
Display panel goes off
and Start button flashes.
Not a fault. Energy-saving mode is active
~
Page 7 .
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out. Not a fault; the dryer may be positioned on an incline. Level the dryer.
Laundry is not dried cor-
rectly or is still too damp.
■
After the end of the programme, warm laundry feels damper than it actually
is. Spread the laundry out and allow the heat to disperse.
■
Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry becomes drier
~
Page 15 .
■
Select a programme with a longer drying time or increase the drying level.
This does not increase the temperature.
■
Select a time programme for subsequent drying of laundry that is still damp
~
Page 15 .
■
If you have exceeded the maximum load for the programme, the laundry
may not be dried properly.
■
Clean the moisture sensor in the drum. A fine layer of limescale may
adversely affect the performance of the sensors and your washing will not
dry properly
~
Page 13 .
■
Drying has been interrupted as a result of a power cut, because
the condensate container is full or because the maximum drying time has
been exceeded.
Note: See also the laundry tips
~
Page 22 .
* Depending on the model