en
Basic settings
18
Display
Basic setting
Selection
Waiting time until a setting is adopted
= 3 seconds
1
= 6 seconds
= 10 seconds
Button tone when pressing a button
= off
= on
1
Brightness of the display illumination
= dark
= medium
1
= bright
Time display
= hide the time
= display the time
1
Childproof lock can be adjusted
→
= no
= yes
1
Interior lighting during operation
= no
= yes
1
Cooling fan run-on time
= short
= medium
1
= long
= extra long
Telescopic shelves retrofitted
2
= no
1
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
Sabbath mode available
= no
1
= yes
Water hardness
→
"Setting the water hardness", Page 18
= softened
= soft (up to 1.5 mmol/l)
= medium (1.5–2.5 mmol/l)
= hard (2.5–3.8 mmol/l)
1
= very hard (above 3.8 mmol/l)
Automatic rapid heating from 200 °C
2
= no
= yes
1
Reset all values to factory settings
= no
1
= yes
..
Home Connect Settings
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
13.2 Changing basic settings
Requirement:
The appliance is switched off.
1.
Press and hold the button for approximately
four seconds.
a
The first basic setting appears in the display,
e.g. .
2.
Use the temperature selector to change the setting.
3.
Use the or button to switch to the next basic set-
ting.
4.
To save the changes, press and hold the button
for approx. four seconds.
Note:
Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Discarding changes to the basic
settings
▶
Turn the function selector.
a
All changes are discarded and not saved.
13.4 Setting the water hardness
ATTENTION!
If the wrong water hardness has been set, the appli-
ance cannot remind you to descale it at the right time.
▶
Set the water hardness correctly.
Using unsuitable liquids may damage the appliance.
▶
Do not use distilled water, highly chlorinated tap wa-
ter (>40 mg/l) or other liquids.
▶
Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
Requirements
¡
Before you set the water hardness, ask your water
supplier about the hardness of your tap water.
¡
The appliance must be switched off.
1.
Press and hold the button for approximately
four seconds.
a
The first basic setting appears in the display,
e.g. .
2.
Use the or button to switch to the next basic set-
ting .
3.
Use the temperature selector to set the water hard-
ness.
