NEFF M15R42X2/01, Инструкция по установке, Страница: 4 / 4

en
Ú
Installation instructions
You must note the following
Electrical connection:
Must only be carried out by a licensed
expert. Incorrect connection will invalidate the warranty.
Installation:
Must only be carried out by a professional. The
fitter is liable for any damage.
Hob and cooker:
Must only be from the same brand and have
the same combination feature.
Protection against accidental contact:
Must be ensured
through the manner of installation.
Installation instructions:
Must be observed for the cooker.
Work surface:
Level, horizontal, stable.
The work surface - Fig. 1
Fitting unit:
Heat resistant to at least 90°C.
Use only water-resistant work surfaces (e.g. natural stone).
Wooden work surfaces must only be used with special
accessories available from specialist retailers.
Cut-out:
To be prepared only in a specialist workshop. The
stability of the work surface must be maintained.
Preparing the units - Figure 2
Tiled work surfaces:
If necessary, raise the support surfaces
with water-resistant battens.
Fitting and connecting the hob - Figs 3 and 4
The cooker must be connected to the mains, but switched off.
Put the
hob
down as shown in Fig. 3.
1.
Screw the hob's
PE conductor (green/yellow)
onto the cooker
earthing point
<
.
2.
Plug the
hotplate plug
into the cooker - see Fig. 4. The colour
of the cable must correspond to the colour shown on the label.
The lug
N
on the plug must point to the left.
Installing:
Install and adjust the hob so that it is horizontal. The
ceramic plate should be positioned slightly below the work
surface.
Securing the hob - Fig. 5
Check that the appliance works correctly and is in the correct
position. Use a suitable silicon adhesive to fill the gap between
the work surface and the ceramic plate. Before a skin forms,
smooth the silicone adhesive with a scraper or your finger
wetted with soapy water.
If you use an unsuitable silicone adhesive on natural stone work
surfaces, it may cause discolouration. A suitable adhesive can
be obtained from our after-sales service.
Removing the appliance
Disconnect the appliance from the power supply.
Slice open the seal around the ceramic plate.
Pull out the cooker a short distance.
Unplug the cooking zone plug.
Finally, disconnect the
PE
conductor (green/yellow) from the
earthing screw.
Push out the hob from below.