NEFF D46ML54N0B, Инструкция по установке и эксплуатации

Страница: 6 / 20

en
Operating the appliance
6
1
Operating the appliance
Operating the appl iance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Control panel
Setting the fan
Switching on
Pull out the filter pull-out and press the
#
button. The
fan starts at setting
ƒ
.
Press the + or - button to change the fan strength.
Switching off
Press the
#
button. Slide the filter pull-out in.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the
˜ button. ˜ƒ appears in the display. Press
the - button to switch back to the intensive setting ˜‚ .
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before this time expires, press the ˜
button.
Fan run-on time
Press the - button until – appears, or slide in the filter
pull-out.
After approx. 10 minutes, the fan switches off
automatically.
AirFresh function
Press the - button until
3 ‚
appears. The fan runs for
approx. five minutes per hour.
If you want to end the AirFresh function, press the
#
button.
Noise reduction function
The noise reduction function reduces the fan noise.
Switching on the appliance
Press the 4 button.
The function is possible in all fan settings, except in fan
setting
‚
. It also remains active after the fan is switched
off.
Switching off the appliance
Press the
4
button.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
A button.
Setting the brightness
Press and hold the
A
button until the desired
brightness is reached.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off. In addition, this
symbol is indicated on the display: ª
If you have not yet done so, the metal mesh grease
filters should be cleaned now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
Cleaning and
maintenance.
While the saturation display is flashing, it can be reset.
To do this, press the – button.
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
#
and + at the
same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Explanation
#
Fan on/off
4
Noise reduction
- Reduce the fan settings/fan run-on time/interval ventilation
+ Increase the fan settings/intensive setting 1, 2
˜
Direct selection of intensive setting 2
A
Light on/off/dimming
IUHVK
YRO
YRO