Installation instructions
en
13
7.
Use the enclosed template to mark the fastening
points on the inside of the cabinet and use a
bradawl to make indentations where the holes are
to be.
8.
Screw in the four enclosed screws for the angle
bracket up to 5 mm.
Preparing the appliance
1.
Insert the holders for the wall edging strip on the
outside rear of the appliance into the cut-outs and
fold them in to the centre of the unit.
2.
Use the screws provided to secure the handle strip
to the filter pull-out.
3.
Connect the enclosed power cord to the appliance
and secure the stain relief.
4.
Screw the two angle brackets to the appliance. Note
the position of the screws. Screw in the screws until
8 mm of the threaded section is still protruding.
Installing the appliance
1.
Use the angle brackets to hang the appliance on
the screws, align it and tighten it.
2.
Appliance width 90 cm: Pull the filter pull-out out
completely towards the front. Also use two screws
each on the left and right to screw the appliance to
the side upper cabinets from below.
Содержание D46BR12X6
Страница 15: ......