NEFF D39L49S0, Инструкция по эксплуатации

Страница: 6 / 12

6
Operating the appliance
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note:
Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Setting the fan
Note:
Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
Press button 1, 2 or 3.
To confirm the setting, the 0 button and the set fan speed light
up.
Switching off the appliance
Press the 0 button.
Fan run-on time
The fan run-on is possible in any fan speed.
1.
First, press the button for the required fan speed 1, 2 or 3.
2.
To activate the fan run-on, press and hold the % button for
2 seconds.
To confirm the setting, the 0 button and the set fan speed
flash.
3.
To end the fan run-on early, press the 0 button.
Notes
■
The run-on time for all fan speeds is 30 minutes. Once this
time has elapsed, the ventilation and lighting automatically
switch off.
■
The fan speed can be changed during the run-on time.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
1.
To activate the intensive setting, press and hold the g button
for 2 seconds.
To confirm the setting, the 0 button lights up and the
g button
flashes.
2.
To end the intensive setting early, press the 0 button.
Note:
The time of the intensive setting is 6 minutes. Once this
time has elapsed, the appliance switches back to the fan
setting that was previously set.
Lighting
The lighting can be switched on and off independently of the
ventilation.
Press the
@
button.
Setting the brightness
When switching on the lights, press and hold the
@
button for
2 seconds. The brightness is reduced.
Note:
When switching on the lights again, the brightness is set
to maximum once again.
Cleaning and maintenance
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Cleaning agents
Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning
agent. Do not use
■
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
Explanation
0 Fan off
1 Fan speed 1
2 Fan speed 2
%
Fan run-on
3 Fan speed 3
g
Intensive setting
B
Light on/off