NEFF C88FT38 0B Series, Инструкция по эксплуатации

Страница: 20 / 68

en
Steam
20
Cancelling
Press and hold the
#
touch button until the appliance
operation is cancelled.
Finishing
Touch the
#
touch button to switch the appliance off.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly.
~
"Basic settings" on page 24
:
Warning – Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning – Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Caution!
Malfunctions may occur when using filtered or
demineralised water.
The appliance may request that you top up the water
tank even though it may be full, or operation with steam
is cancelled after approx. two minutes.
If required, mix filtered or demineralised water with the
bottled non-carbonated mineral water with a ratio of
one to one.
Notes
■
If your water is very hard, we recommend that you
use softened water.
■
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
■
If you use mineral water, set the water hardness
range to "4 very hard".
■
If you use mineral water, you must only use non-
carbonated mineral water.
1.
Touch the
”
touch button.
The control panel is pushed forwards automatically.
2.
Pull the control panel forwards with both hands and
then push it upwards until it locks into place (Fig.
!
).
3.
Lift the water tank and remove it from the water tank
recess (Fig.
"
).
4.
Press down on the cover along the seal to prevent
water from leaking out of the water tank.
5.
Take out the cover
‚
(Fig.
#
).
Note:
Whether or not there is a cover
‚
depends on
the appliance type.
6.
Fill the water tank with cold water up to the "max."
mark (Fig.
$
).
7.
Put the cover
‚
back into the opening on the water
tank.
8.
Insert the filled water tank (Fig.
%
). Ensure that the
water tank locks into place behind both holders
ƒ
(Fig.
&
).
9.
Slowly slide the control panel downwards and then
push it towards the rear until it is closed completely.
The water tank has been filled. You can start using
operating modes with steam.
Refilling the water tank
Notes
■
Steam-assisted operations continue without adding
steam.
■
If the water tank runs dry during operation with the
Steaming, Dough proving, Defrost or Reheat
settings, operation is interrupted. Fill the water tank.
2I 1
D
E
E
I