NEFF B59CR3A 0 Series, Руководство пользователя и инструкции по установке, Страница: 28 / 44

en
Troubleshooting
28
21 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
→
"Customer Service", Page 29
WARNING ‒ Risk of electric shock!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by trained specialist staff.
21.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not
working.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Electronics fault
1. Disconnect the appliance from the power supply for at least 30 seconds by switching off
the fuse.
2. Reset the basic settings to the factory settings.
→ "Basic settings", Page 15
"Sprache Deutsch"
appears in the dis-
play.
There has been a power cut.
▶
Configure the initial configuration settings.
→ "Initial use", Page 10
The operation does
not start or is inter-
rupted.
Different causes are possible.
▶
Check the notifications that appear on the display.
→ "Displaying information", Page 11
Malfunction
▶
Call the after-sales service.
→ "Customer Service", Page 29
Appliance does not
heat up.
Demo mode is switched on.
1.
Disconnect the appliance from the power supply for at least 30 seconds by switching off
the fuse.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
→ "Changing basic settings", Page 16
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a
The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
▶
Change the basic setting for the clock.
→ "Basic settings", Page 15
Home Connect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
The interior lighting
does not work.
Basic setting has been changed.
▶
Change the basic setting for the lighting.
→
"Basic settings", Page 15
The LED light is defective.
▶
Call the after-sales service.
→
"Customer Service", Page 29