NEFF B4ACM5HH0B, Руководство пользователя и инструкции по установке

Страница: 21 / 40

Shelf supports
en
21
spots are not rust. These spots are not harmful.
These marks do not impair the cleaning ability of
the self-cleaning surfaces.
3.
Attach the shelf supports.
→
"Shelf supports", Page 21
16.2 Base clean
Use the
Base clean
to clean the cooking compartment
floor. The
Base clean
softens dirt by vaporising the
soapy water. The dirt can then be removed more eas-
ily.
Setting Base clean
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
▶
Never pour water into the cooking compartment
when the cooking compartment is hot.
Notes
¡
The interior lighting remains off while the cleaning
aid is running.
¡
You cannot delay the end time.
¡
The length of time has been preset and cannot be
changed.
Requirements
¡
You can only start the cleaning aid once the cooking
compartment is cold (room temperature) and the ap-
pliance door is closed.
¡
Do not open the appliance door while the appliance
is in operation. Otherwise, the appliance will stop the
cleaning aid.
¡
To remove particularly stubborn dirt, leave the soapy
water to work for some time before starting the
cleaning aid.
¡
To remove particularly stubborn dirt, rub soapy water
onto the dirt on smooth surfaces before starting the
cleaning aid.
1.
Remove the accessories from the cooking compart-
ment.
2. ATTENTION!
Distilled water in the cooking compartment leads to
corrosion.
▶
Do not use distilled water.
Mix 0.4 litres water with a drop of washing-up liquid
and pour into the centre of the cooking compart-
ment floor.
3.
Use the function selector to set the cleaning
functions ⁠.
a
The symbol and the cleaning functions appear in
the display. The first cleaning function is highlighted.
4.
Press the or button repeatedly until the symbol
is highlighted.
a
appears in the display.
5.
Turn the temperature selector.
a
appears in the display.
a
The cleaning aid starts after a few seconds. The
duration counts down in the display.
a
Once the cleaning aid has run through to the end,
an audible signal sounds.
Note:
If flashes in the display when the cleaning aid
is switched on, this indicates that the cooking compart-
ment has not completely cooled down. Switch off the
appliance. Wait until the cooking compartment has
cooled down and switch the cleaning aid back on.
Recleaning the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶
After using the cleaning aid, wipe the cooking com-
partment clean and allow it to dry fully.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Stubborn
residues can be removed using a stainless steel
scouring pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4. If you are unable to remove stubborn dirt, repeat the
cleaning aid after the cooking compartment has
cooled down.
5.
To switch off, turn the function selector to the zero
setting.
6.
Lower the appliance door and leave it open for ap-
prox. one hour to allow the surfaces in the cooking
compartment to dry thoroughly.
‒
You can also dry the cooking compartment
quickly.
→
"Drying the cooking compartment quickly",
Page 21
Drying the cooking compartment quickly
1.
After the cleaning aid has completed, lower the ap-
pliance door.
2.
Start
CircoTherm hot air
at 50 °C.
3.
After five minutes, switch off the appliance and
close the appliance door.
17 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
17.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it ⁠.