23
Removing the door panel
Note:
Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Carefully lift the door panel slightly and remove it in the
direction of the arrow (fig. A).
Removing the intermediate panel
Note:
Before removing, make a note of the position in which
the intermediate panel is fitted, so that you do not refit it the
wrong way round later.
1.
Remove the seal. Pull the seal outwards and remove it
upwards (fig. B).
2.
Release and remove the retainer (fig. C).
3.
Lift the intermediate panel slightly and take it out (fig D).
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
Note:
During installation, make sure that the lettering "top right"
is upside down at the bottom left.
1.
Insert the intermediate panel towards the back as far as it will
go (fig. A).
2.
Hook in the seal on both sides (fig. B).
3.
Insert the retainer (fig C).
4.
Press down on the retainer until it locks into position (fig. D).
Fitting the door panel
1.
Insert the door panel at an angle towards the rear into the
retainers (fig. E).
2.
Press down on the side of the door panel until it locks into
place (fig. F).
3.
Refit the appliance door.
$
%
'
&
%
$
'
&
)
(
