NEFF B45E74.3GB, Инструкция по эксплуатации, Страница: 28 / 32

28
Replacing the oven light bulb
Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
1.
Place a tea towel in the cold cooking compartment to prevent
damage.
2.
Turn the glass cover anticlockwise and remove it.
3.
Replace the oven light bulb with a bulb of the same type.
4.
Screw on the glass cover again.
5.
Remove the tea towel and switch on the circuit breaker.
Note:
If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing halogen bulbs
Spare bulbs can be obtained from the after-sales service or
specialist retailers. Verwenden Sie nur diese Halogenlampen:
Osram HALOSTAR ECO, 12 V, GY 6.35, 25 W
:
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
1.
Remove the appliance door (see section: Removing and
refitting the appliance door).
2.
Remove the door panel (see section: Cleaning the door
panels).
3.
Defekte Halogenlampe zusammen mit der Lampenfassung
aus der Halterung ausrasten und vorsichtig aus dem
Reflektor herausnehmen.
4.
Defekte Halogenlampe aus der Lampenfassung
herausziehen (Bild A).
5.
Neue Halogenlampe in die Lampenfassung einsetzen.
Verwenden Sie hierfür ein sauberes Tuch (Bild B).
6.
Lampenfassung wieder in die Gerätetür einsetzen.
7.
Fit the door panel and appliance door.
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
1.
Unhook (Fig. B) the door seal at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
the hooks slightly (Fig. D).
Hooking in the door seal
1.
Hook (Fig. B) the door seal in at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
it slightly (Fig. D).
3.
Check that the door seal is seated correctly.
% $
$ %
& '