NEFF B45C42.0, Инструкция по эксплуатации

Страница: 30 / 36

30
Removing the door panel
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Disengage and pull out the door panel from the latch on the
appliance door by lifting slightly.
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
1.
Push the brackets on the left and right-hand sides outwards
(Fig. A) and unhook the intermediate panel.
2.
Raise and pull out the intermediate panel (Fig. B).
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
1.
Insert the intermediate panel into the three supports (Fig. A).
2.
Press on the intermediate panel on the left and right next to
the holders until it engages in the holders (Fig. B).
Fitting the door panel
1.
Insert the door panel into the two supports (Fig. A).
2.
Press on the door panel on the left and right next to the
holders until it engages in the holders (Fig. B).
Cleaning the cooking compartment ceiling
The grill element can be folded down to allow quick and easy
cleaning of the cooking compartment ceiling.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Pull the grill element retaining bracket towards the front and
push it upwards until you hear the grill element disengage
(figure A).
2.
Hold the grill element and fold it downwards (figure B).
3.
Clean the cooking compartment ceiling.
4.
Pull the retaining bracket towards the front and keep it
pushed upwards.
5.
Fold the grill element upwards, until it clicks into place.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
$ %
$ %
$ %
$ %
$ %
D
D
& '