NEFF B3ACE2A.0, Руководство пользователя и инструкции по сборке, Страница: 15 / 32

Cleaning function
en
15
12.3 Checking the cooking compartment
seal after cleaning
▶
If the cooking compartment seal is on the left or
right of the spacer , slide the cooking compart-
ment seal inwards until it is beside the spacer ⁠.
13
Cleaning function
You can use the cleaning function to clean the appli-
ance.
13.1 Cleaning aid EasyClean
Use the cleaning aid
EasyClean
for intermediate clean-
ing of the cooking compartment. The cleaning aid
EasyClean
softens dirt by vaporising the soapy water.
The dirt can then be removed more easily.
Setting the cleaning aid EasyClean
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
▶
Never pour water into the cooking compartment
when the cooking compartment is hot.
Notes
¡
You cannot delay the end time.
¡
The length of time has been preset and cannot be
changed.
Requirements
¡
Start the cleaning aid only when the cooking com-
partment has completely cooled down.
¡
To remove particularly stubborn dirt, leave the soapy
water to work for some time before starting the
cleaning aid.
¡
To remove particularly stubborn dirt, rub soapy water
onto the dirt on smooth surfaces before starting the
cleaning aid.
1.
Remove the accessories from the cooking compart-
ment.
2.
ATTENTION!
Distilled water in the cooking compartment leads to
corrosion.
▶
Do not use distilled water.
Mix 0.4 litres water with a drop of washing-up liquid
and pour into the centre of the cooking compart-
ment floor.
3.
Use the function selector and the temperature se-
lector to set the cleaning aid ⁠.
a
The length of time appears in the display.
a The cleaning aid starts after a few seconds. The
duration counts down in the display.
a Once the cleaning aid has run through to the end,
an audible signal sounds.
Note:
If flashes in the display when the cleaning aid
is switched on, this indicates that the cooking compart-
ment has not completely cooled down. Switch off the
appliance. Wait until
appears in the display and
switch the cleaning aid back on.
Recleaning the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶
After using the cleaning aid, wipe the cooking com-
partment clean and allow it to dry fully.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Stubborn
residues can be removed using a stainless steel
scouring pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
If you are unable to remove stubborn dirt, repeat the
cleaning aid after the cooking compartment has
cooled down.
5.
To switch off, turn the function selector to the zero
setting.
6.
Lower the appliance door and leave it open for ap-
prox. one hour to allow the surfaces in the cooking
compartment to dry thoroughly.
‒
You can also dry the cooking compartment
quickly.
→
"Drying the cooking compartment quickly",
Page 15
Drying the cooking compartment quickly
1.
After the cleaning aid has completed, lower the ap-
pliance door.
2.
Start
CircoTherm hot air
at 50 °C.
3.
After five minutes, switch off the appliance and
close the appliance door.