Page 8 of 12
Installation Procedure
Step 1: Prepare opening
Using appropriate tools, cut an opening in the mounting surface
with the dimensions shown on the supplied
cutout template. The template is found in the cardboard box.
Remove the back of the template and stick it on the mounting
surface (also used to protect when cutting).
Cut according to markings using appropriate tools, e.g. a jigsaw.
Step 2: Adjust depth of connector plate
If you need a different depth of the plates inside the box you can
adjust them as here bellow.
Remove the height adjustment screws.
Turn the unit and then remove back cover and the height adjust-
ment screws.
Supporting the connector plate from underneath with your
fingers, bring the connector plate to the required position. Then
replace and tighten the height adjustment screws.
