VP1006-200PM-00 OEM ISO Reader
Manual version 2.6 / Page
1
Preface
This manual is part of the service documentation for Nedap Velos. Reference is also made to other
manuals that are part of the Nedap Velos documentation. For an overview of available Nedap Velos
manuals see the manual “Nedap Velos General Description”, or visit the Nedap Agri website
www.nedap-agri.com.
1
Introduction
The Velos VP1006 is used for identification of animals for feeding, weighing, milking, heat detection
etc. The VP1006 must be connected to a computer (controller) and can communicate by a CAN,
RS485 or RS232 protocol. The connected computer must give controlling commands to the VP1006 to
operate inputs, outputs and identification.
The VP1006 has the following main tasks:
-
Identification of tags (ISO 134.2 kHz FDX/HDX)
-
Controlling outputs - 6 outputs are available to activate e.g. lights, motors, valves, relays
-
Reading inputs - 6 inputs available for e.g. sensors, switches
Following antenna types can be used:
-
V-sense antennas
-
EWA transformer with stainless steel antenna strip
-
HDPE antenna with HDPE antenna tuner
The VP1006 must be installed in a housing suitable for farm conditions, for example in a V-box.
Figure : V-box2 with a VP2002 power supply and a VP1006 reader
Reference manuals :
PS0000-200PM-00 Velos general description
VP1002-200PM-00 ISO-Booster
VP6001-200PM-00 V-sense
FCC ID: CGDVELOS2 and IC: 1444A-VELOS2
FCC_IC Statement
This device complies with part 15 of the FCC Rules and
with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Warning (15.21)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to
operate the equipment.
Cet appareil se conforme aux normes RSS exemptés de license du Industry Canada. L'opération est soumis aux deux
conditions suivantes:
(1) cet appareil ne doit causer aucune interférence, et
(2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut causer une opération non pas voulu de
cet appareil.
Les changements ou modifications n’ayant pas été expressément approuvés par la partie responsable de la conformité peuvent
faire perdre à l’utilisateur l’autorisation de faire fonctionner le matériel.
