TRANSIT Ultimate | installation guide
12/40
2.5
Installing a communication board
The TRANSIT Ultimate features an on-board USB port and a Wiegand / Magstripe / Barcode interface. See chapter 4.3
for more details.
Other communication interfaces can modularly be installed in the reader by means of a communication interface board.
There are various communication interface boards available for the TRANSIT Ultimate. See appendix C for available
boards and their part numbers.
Make sure to follow all safety precautions outlined in chapter 2.1 when installing or replacing a communication board.
Communication board installation procedure:
1.
Open the TRANSIT Ultimate. You can put the cover strut into place to keep the cover open.
2.
Disconnect the power supply.
3.
Place the communication interface board on the 14-pin header K5 as indicated in the picture below.
4.
Make sure that the 4 plastic PCB supports are properly positioned and fixed into the communication board.
5.
Read the communication board’s installation guide for additional notes like address setting, jumper settings and
wiring details.
6.
Test if the communication works correctly.
7.
Close the cover of the TRANSIT Ultimate.
PCC485/OSDP
The PCC485/OSDP converter board is not installed as described above.
Please refer to chapter 3 for more details.
