NVITE | installation guide
18/40
4.3
Settings
4.3.1
General
Hold time / repeat time
Set tag hold time. Default 1 sec. Max. 25 sec.
Enable 'repeat using hold-time interval' to repeat the communication output while the tag remains within read range.
Configuration password
Enter a configuration password to lock the configuration settings in the reader. Without the password you cannot
change any configuration settings. Please remember this password very carefully. By default the reader has no
configuration password.
Nedap customer codes
The NVITE reader is programmed with a customer code. Nedap tags or credentials may also have a customer code.
Enable 'Read only if customer code is correct' to make the reader ignore tags that have a different customer code.
You may change the customer code(s) in the reader. You can configure up to 20 customer codes in the reader.
Identifiers without customer code
Other tags or credentials may not have a customer code. For example MIFARE DESFIRE cards, custom QR-codes or the
Mobile ID Raw ID64 credentials. Enable or disable 'Allow reading ID-numbers without customer code'.
Heater
The NVITE reader has a heater unit to prevent condensation on the QR-code scanner at low temperatures. By default
the heater unit is off.
ID-source values
The NVITE reader indicates on which source there was an identification. These ID-source identifier values are
configurable by clicking on the link.
Antenna modulation
This setting is only used for the Nedap antenna interface. See chapter 3.7. The setting defines how often the ID-number
is sent on the antenna interface. Default settings is 30 cycles, which corresponds to ± 1 sec.
