Nedap 9217967, Руководство пользователя, Страница: 9 / 24

9
Below table
When looking for a good spot to mount the antenna, make sure the table doesn’t have any metals
near the antenna (field). When a good spot is found, you will need 4 fastening screws (corresponding
to your table material), and a drill to prepare the table.
Tape the template (which you can cut out from the next page) on the surface where you want to
place the antenna. Make sure to take into account the minimum distances from the sides of the
template. These go both ways.
Open up the MidRange Antenna, by carefully removing the screws on the bottom of the product. Put
the hood in the desired position, and drill four holes through the hood into the table while holding
the hood in place. Make sure to use a smaller drill than the diameter of the screw, so that the screw
will tap itself further into the table.
TIP: Use DuctTape, or a clamp to keep the hood in place, whilst drilling the
holes and mounting the hood with the screws. (Remove when remounting the
bottom)
Re-attach the bottom of the antenna to the mounted hood. Be careful not to destroy the thread in the
mounting points of the hood when doing so.