NED
RMSL8K76CP/RMSL6K76CP/RMSL4K76CP UME-0094-02
4
Instructions before use
◆
Only operate this product within the recommended environmental temperature
range.
◆
Use only the specified power source and voltage rating.
◆
Do not drop this product. Avoid exposure to strong impact and vibrations.
◆
Install the camera unit in a well-ventilated environment, in order to prevent the
camera from overheating.
◆
If the camera must be installed in an environment containing dust or other particles,
take required measures to protect the camera unit from dust adhesion.
◆
Do not unplug the cable while power is being supplied to the camera unit. To
prevent product damage, always shut down the power supply before unplugging
the power cable.
◆
When the surface of the camera window becomes dirty due to dust or grime, black
smudges appear in the displayed image. Use an air blower to remove the dust
particles. Dip a cotton swab into ethanol alcohol and clean the camera window. Be
careful not to scratch the glass.
◆
Use of non-infrared lighting such as a fluorescent lamp is recommended. If halogen
lighting is employed, always install an infrared filter into your system configuration.
◆
Please note that exposure to long wavelength light outside of the sensors visible
optical range can affect the image.
◆
Sensitivity may fluctuate depending on the spectral response level of the light
source. In cases like this, changing the light source to one with a different spectral
response level may reduce this problem. Moreover, this irregular sensitivity can be
completely lost by using 4.11 pixel correction function. Please refer to 4.11 pixel
correction function for details.
◆
Note that when the sensor is exposed to excessive quantities of light, blooming
may occur, because this product does not have a special Anti-Blooming function.
◆
For stabilized image capturing, turn on the power supply and execute aging for ten
to twenty minutes before actually using the camera unit.
◆
Do not share the power supply with motor units or other devices that generate
noise interference.
◆
The signal ground (SG) and the frame ground (FG) are connected inside the
camera unit. Design the system configuration so that a loop will not be formed by
the ground potential differential.
◆
Do not disconnect the camera while rewriting an embedded memory.
◆
When using external trigger, change the setting with the trigger packet supplied
beforehand from the frame grabber board.
