NEC Versa S900, Руководство по разборке

Страница: 3 / 19

NEC Versa S900 Disassembly Manual Page 3
Overview
This document contains step-by-step disassembly instructions for the Versa S900 chassis. The instructions are
illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws
that are removed are shown next to the image of the parts themselves.
NEC reserves the right to make changes to the Versa S900 chassis without notice.
Technician Notes
Only technicians authorized by NEC Computers International BV should attempt to repair this equipment. All
troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the
complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component
level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any
indication of component replacement or printed wiring board modifications may void any warranty or exchange
allowances.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
„
Do not disassemble the system into parts that are smaller than those specified in the instructions.
„
Label all removed connectors. Note where the connector goes and in what position it was installed.
„
Turn off the power and disconnect all power and all options.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are returned
to their proper positions. Check that no tools or any loose parts have been left inside the chassis. Check that
everything is properly installed and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
„
Tweezers
„
Small Philips screwdriver #0, #1
„
Small Flat screwdriver Ø 1.4 mm, 2.0 mm
„
Spacer screwdriver Ø 5 mm