NEC Versa P700 Disassembly Manual
Page 24
4. Carefully lift the IDE/Audio vertically to disconnect it from the main board and put it
aside.
Note:
The IDE/Audio board is connected to the main board through two connectors. These connectors
are located underneath the IDE/Audio board.
Removing the Main Board
To remove the main Board, first remove the keyboard (see
), remove
the LED assy (see
), remove the LCD assembly (see
), remove the Hard disk drive
), remove the touchpad assembly (see
), remove the heat plate (see
), remove the plastic cover
), remove the wireless LED board (see
), remove the speaker set (see
), remove the
Removing the IDE/Audio Board and Microphone
), then follow the next
steps:
1. Remove the last two screws holding the heat sink covering the chipset..
Fig. 46:
Removing chipset heat sink
2. Remove the two screws shown next and take out the metal brackets that the screws
held in place.
Fig. 47:
Removing brackets
(M2x3)
(M2.5x5)
Содержание Versa P700
Страница 1: ...NEC Versa P700 Disassembly Manual ...
Страница 28: ...NEC Versa P700 Disassembly Manual Page 28 ...
