NEC Versa P700, Руководство по разборке

Страница: 18 / 29

NEC Versa P700 Disassembly Manual
Page 18
Fig. 32: Removing the flat cable from the touchpad
7. Remove the screws marked in the next picture and finally lift the touchpad out of the
assembly.
Fig. 33: Removing the touchpad screws
Removing the Speaker Set
To remove the speaker set, first remove the Hard disk drive cover (see Removing the Hard
Disk Drive ), remove the touchpad assembly (see Removing the Touchpad ), then perform the
next steps:
1. Remove the one screw holding down the left speaker.
2. Disconnect the speakers from the audio board (refer to the picture below for the location
of screw and connector mentioned).
Fig. 34: Removing the speaker set
A (M2x3)
B (M2x3)
(M2x6)