4 NEC Versa 6050 Windows 98 Upgrade Information
Windows 98 graphic appears asking you if you want to upgrade to Windows
98. If you see the graphic, answer “Yes” and skip to step 3. If you do not see
this graphic, continue to step 2.
2.
Use Windows Explorer to navigate to the Windows 98 Setup utility, at the
root of the CDROM drive – (your CD-ROM drive will most likely be E:).
3.
Double click on the Setup icon. The Setup Wizard guides you through the
installation process. Answer all prompts appropriately.
Note:
You must to make three key decisions
depending on your particular needs and system
configuration. Use the following guidelines.
Concerning docking stations: You should perform the
Windows 98 upgrade in the mode (docked or undocked)
which you use most often. This is purely a decision of
convenience, as Windows 98 upgrades docking
configurations on an “as detected” basis.
Early during the Windows 98 upgrade process you are
prompted to decide if you want to back up your Windows
95 system files. Whether or not you backup your
Windows 95 system files is a judgement decision that is
left entirely to you. Just keep in mind that approximately
50 MB of hard drive space will be consumed by doing so.
NEC recommends that you back up your system
files.
Early during the Windows 98 upgrade process you are
prompted to make a Windows 98 bootable Startup
diskette, which loads CD-ROM drivers. If your system
cannot run both a floppy drive and a CD-ROM drive at
the same time, skip this section by selecting “Cancel” at
the “Insert diskette” screen. Later, when you have the
floppy drive installed, go to the Control Panel,
Add/Remove Programs, select the “Windows Setup” tab,
and create a startup diskette.
NEC Versa 6050
Windows 98 Upgrade Information
819-200530-000 Rev. 00
7/98
