Figure 2-9 Details of a Device connection
The actions that can be performed via the WEB Browser interface are shown
below.
Notes
1.
If you click the SW3 of the coordinator, LED3 on the physical Device 1 turns
on, and then, off .
2.
If you click the SW2 of the coordinator, LED2 on the physical Device 1 turns
on, and then, off.
3.
If you click any LEDs (LED1, LED2, LED3 or LED4), the corresponding LED
on the physical board will turn on, and off.
4.
View of status information for the Device:
•
Address: This is the MAC address of the Device in IEEE
802.15.4.
•
Temperature: Measured on the Device
•
SW pressed: Indicates which switch was pressed on the
Device.
•
Time pressed: Time stamp of the pressed switch.
5.
LEDs (LED2, LED3 or LED4) can be on and off.
6.
If the SW3 of the Device is clicked, LED1 of the coordinator is on and off.
The information at the Note 4, SW pressed, and Time stamp, will be
updated.
7.
If the SW4 of the Device is clicked, LED2 of the coordinator is on and off.
The information at the Note 4, SW pressed, and Time stamp, will be
updated.
Sample Program
Chapter 2
User's Manual U19026EE3V0UM00
17