NEC UNIVERGE WL, Быстрое руководство по установке

Страница: 22 / 34

1-16
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
• Attach the ceiling-mount base to the bottom of the UNIVERGE WL AP
using the factory-supplied machine screws and washers.
• Position the ceiling-mount base so its keyhole slots are partly on the
drywall, sheet metal, or other screw heads installed in
Step 3: Preparing
Mounting Locations .
• Attach the cables to the sides of the UNIVERGE WL AP.
• Slide the ceiling-mount base onto the drywall, sheet metal, or other
screw heads until it snugs into place.
You have installed the UNIVERGE WL AP. Repeat Step 4: Mounting the
UNIVERGE WL APs for each UNIVERGE WL AP location, and then continue with
Step 5: Returning MAC Information .
Ceiling-Mount Clips
Ceiling-Mount Clips
When you are mounting the UNIVERGE WL AP on the extruded aluminium rails
of a hanging ceiling, use the ceiling-mount clips to mount the UNIVERGE WL AP
as shown in the following figure and as described below:
Figure - Assembling the UNIVERGE WL AP and Ceiling-Mount Clips
NOTE
If the screws do not securely hold the ceiling-mount base, remove the
UNIVERGE WL AP and adjust the screws until they hold the ceiling-mount
base securely.
NOTE
When the UNIVERGE WL AP is powered up and is associated with an
UNIVERGE WL Wireless Controller (Green/Power and Yellow/802.11b/g
and/or Yellow or Amber/802.11a LEDs lit), the UNIVERGE WL AP is
broadcasting its beacon signal(s). When this happens, complete the
installation as quickly as possible to remove yourself from within 8 inches
(20 cm) of the UNIVERGE WL AP to comply with FCC RF radiation
exposure guidelines.