Issue 1.0
IDT/Net2Phone
14
SIP Trunking Service Configuration Guide
10-29-01 : SIP Server Information Setup – Outbound Default Proxy
Enable (1) the SIP Outbound Proxy.
.
If entries are made in Program 10-29-xx for a SIP Server and the SIP Server is then removed
or not used, the entries in Program 10-29-xx must be set back to their default settings. Even
if 10-29-01 is set to .0. (off), the SV9100 will check the settings in the remaining 10-29
programs.
10-29-03 : SIP Server Information Setup – Default Proxy IP Address
Define the SIP Trunk Service Provider Proxy IP Address. You may resolve the IP
address of the Outbound Proxy by pinging the URL.
10-29-5 : SIP Server Information Setup – Registrar Mode
Set the Registrar Mode to 1 (Manual) with SIP trunking.
10-29-6 : SIP Server Information Setup – Registrar IP Address
Input the IP address of the SIP registrar (if given).
10-29-11 : SIP Server Information Setup – SIP Proxy Setup – Registrar
Domain Name
Define the Registrar Domain Name. This information should be provided by your
SIP service provider (128 characters maximum).
10-29-12 : SIP Server Information Setup – Proxy Domain Name
Enter the Domain name.
.
When configuring the Domain name, the SIP service provider will supply the Proxy/
Domain in the following manner - "Host Name" . "Domain Name" . The characters are
normally separated by “.” The characters
after
“.” will be in the Domain Name.
10-29-13 : SIP Server Information Setup – Proxy Host Name
Enter the Host name.
.
When configuring Domain name the SIP service provider will supply the Proxy/Domain in
the following manner - "Host Name" . "Domain Name" . The characters are normally
separated by “.” The characters
before
“.” will be in the Host Name.
10-29-14 : SIP Server Information Setup – SIP Carrier Choice
Set the SIP Carrier Choice to 2 (Carrier B).
.
This setting is not applicable for this carrier test.
10-29-15 : SIP Server Information Setup – Registration Expiry Time
It is
important
to leave this automatic re-registration time to be 3600 seconds so
that the IDT/Net2Phone network does not get flooded.
10-29-16 : SIP Server Information Setup – Register Sub Mode
Unchecking the Register Sub Mode (setting it to “off”) will allow all trunk calls to be
routed based on routing policies.
10-29-21 : SIP Server Information Setup – NAT Router
Disable this Program (NAT Router is not used for this testing).
Содержание Univerge SV9100
