NEC SV8500, Руководство пользователя

Страница: 1835 / 3438

VOL.2-1582
MG-SIP128 [MG-128SIPMGJ]
(5) When multiple connected parties are registered for one Search Number, if Server Priority is assigned to
“Address that is assigned to Primary for Multipoint Data Table is prioritized (fixed)” by “set mp_mode”
command, a normal outgoing call uses the connected party assigned as Primary only when alternate rout-
ing is executed, Secondary or later is used.
When Server Priority is assigned to Round Robin, alternate routing is executed from Primary to Quater-
nary in order.
(6) The number of times executing alternate routings is up to 3 times for each Search Number. When an out-
going call is originated, if there is no data matched with the Search Number in Multipoint Data Table, or
alternate routing is failed, Release Message is sent to the Telephony Server.
Note 1
Note 1:
When alternate routing is originated for no answer, the number of times executing alternate rout-
ings is up to twice.
(7) Multipoint Data Table supports download and upload with TFTP protocol.
(8) When Multipoint Data Table file (CSV format) is uploaded, if there is an existing uploaded file whose
name is the same with the new uploaded file, the existing file is overwritten.
Note: There is no confirmation message for overwriting the existing file.
(9) Fax communications support Fax Passthrough only.
18.6.2 Operating Procedure
Step1: Execute the “set default” command, and then select "y".
Step2: Execute the “set config_template” command, and then select "1".
Step3: Execute the “set ipaddress” command for assigning the IP address and the Subnet mask
of MG-SIP128 [MG-128SIPMGJ].
Step4: Execute the “set drsaddress” command for assigning the IP address and the port number
of DNS Server.
Step5: Execute the “set keynumber” command for assigning the Pilot number of MG-SIP128 [MG-
128SIPMGJ].
Step6: When you change Search Number digits, execute the “set mp_mode” command. If the
Search Number digits have been changed, be sure to save the configuration in the
“reboot “ command and then restart MG(SIP).
Step7: Assign the Connected Party number to each dial number in the Multipoint Data Table by
using either the following method.
• Registration by downloading CSV file