NEC SV8500, Руководство пользователя

Страница: 1198 / 3438

VOL.2-945
MG-PRI/PRA
13.3 System Startup
13.3.1 Summary
After completing hardware settings on the previous page, the setup procedures as follows are taken. These set-
tings are divided into three parts: the settings of the Telephony Server and the settings of MG-PRI/PRA, and
connection check. To set up the MG-PRI/PRA, these procedures are necessary to proceed.
13.3.2 Before Taking Procedures
Before taking procedures, please take the following:
• Connect the maintenance console by using an RS-232C straight-through cable.
• Unstable network environment such as using NAT and dial-up connection is not preferred
• Connecting ISDN is applied for not tie network but PSTN using the following protocol:
- North America:
Bellcore NI-2 AT&T NO5ESS DMS-100
- Other Countries:
ETSI ETS300.102.1
• The following provides the port number to be used in this system. If a firewall is used in your network, do
not block the following ports.
PORT NO.
PATH FUNCTION NOTE
64000 ∼ 65024 PHI-PRI → MG-
PRI/PRA
iLP-PM
Changed by using PCPro belonging to the
Telephony Server. (ADTM)
7500 PHI-PRI ← MG-
PRI/PRA
The initial value can be changed by using
a local console.
1024 ∼ Peer to Peer H.245 Allocated by Operating System.
1024
∼
2048 Peer to Peer RTP The initial value can be changed by using
a local console.
3456 MG-PRI/
PRA
↔ DRS
Registration The initial value can be changed by using
a local console.
10001 Preparation for H.245 is
completed. The initial value can be changed by using
a local console.