7
1. Introduction
Rear
AC IN terminal
Connect the supplied
power cord’s three-pin
plug here, and plug the
other end into an active
wall outlet. (
→
page
Theft prevention screw
hole for the lens unit
Main power switch
While AC power is being supplied, set the
main power switch to ON position (|), then
your projector will enter a standby state.
Power Cord Stopper
(
→
* This security slot supports the MicroSaver
®
Security System.
Built-in Security Slot ( )*
Security Bar
Fixing a theft prevention
device.
The security bar accepts
security wires or chains
up to 0.18 inch/4.6 mm in
diameter.
Handle (located on 4 posi-
tions)
For transportation
NOTE:
• For moving the projector,
make sure you have at least
two people. Attempting to
move the projector alone
could result in back pain
or other injuries.
Intake vent
Takes in air to cool the unit.
(
→
Terminals
(
→
page
Exhaust vent
Heated aiir is exhausted
from here.
(
→
Controls
(
→
)
