136
6. Installation and Connections
Design and manufacturing conditions for the stand
1. To display images in portrait orientation, use a safety cover (sold separately). (
→
page
)
2. Please hire an installation service provider (for a fee) for the design and manufacture of a customized stand to be
used for portrait projection. Please ensure that the design complies with the following conditions:
• There is an intake vent opening on the safety cover. Do not obstruct this opening.
• There are 2 ventilation holes at the bottom of the projector. These holes should remain unobstructed.
• Use the 6 screw holes at the back of the projector to secure it to the stand.
Screw hole center dimension: 300 × 300 (pitch = 150) mm
Screw hole dimension on the projector: M4 with a maximum depth of 8 mm
3 of the legs can be unscrewed for removal.
• Horizontal adjustment mechanism (for example, bolts and nuts in 4 places)
• Please design the stand so that it does not easily topple over.
* We recommend combining ceiling mounts (model NP15CM, sold separately) with an angle adjustment mechanism.
Reference drawings
* The drawing showing the dimensional requirements is not an actual stand design drawing.
32
34
150
150
34
85
300
[Side View]
[Front View]
Screw holes for 6 -
M4 use
□
84 × 108 holes
(Intake vent)
□
40 × 78 holes
(Exhaust vent)
(Unit: mm)
Horizontal adjuster
Intake vent
