NEC PX-60SP3U, Инструкция по эксплуатации

Страница: 4 / 16

4
5
Tighten the loosely inserted screws in 4 locations fully into place.
¶
Tighten the screws while pushing the speakers lightly against the plasma monitor.
Check to be sure that all four screws have been screwed firmly into place.
¶
If there is a large gap between the plasma monitor and the speakers, adjust them after slightly loosening the screws that
were tightened in step 2. After adjustment, re-tighten the screws.
¶
To install the plasma monitor on a wall, it is recommended that you first remove the speaker units, then after the plasma
monitor has been installed on the wall, re-attach the speaker units to the plasma monitor.
Warning
¶
Never hold the speakers when speakers are
attached to the plasma monitor to move the
plasma monitor. Doing so might result in the
plasma monitor falling, and this in turn might
result in bodily injury.
¶
Be sure to screw the screws firmly into place.
Failing to do so might result in the speakers
falling, and this in turn might result in bodily injury.
Connecting speaker cords
Be sure to turn off the power to the plasma monitor before connecting the speakers.
Use the provided speaker cords to connect the R/L speaker jacks of the plasma monitor to the speaker jacks of the speakers.
Once the cords have been connected, pull on the cords lightly to make sure that they have been connected firmly to the speaker
jacks. An improper connection might result in the sound being interrupted or the appearance of noise in the output sound.
Cord clampers
Remove the protective tape from the rear of the cord clampers, attach the
clampers in the desired position, and clamp the cords into place.
Note that the speaker cords have positive
and negative ends, and that you should be
sure to insert them correctly.
Press the button of the speaker jack and
keep it pressed down as you insert the wire
of the speaker cord and then release the
button.
Red
Black