Section 2
Setup and Installation
This section contains information on setting up PowerMate
®
P ETC Series systems.
The following figure shows the location of the interface ports on the rear of the system unit
for configuring PowerMate P ETC Series hardware. Use the procedures described in
Section 2 of the PowerMate V & P Series Service and Reference Manual to set up the
system hardware. For other setup information, see the PowerMate V & P Series Service and
Reference Manual Addendum.
Figure 2-1 Rear Panel I/O Ports
In addition, refer to the following figure for the location of the network interface board
connectors.
