4
Warning
Not for use in a computer room as defined in the Standard
for the Protection of Electronic Computer/ Data Processing
Equipment ANSI/NFPA 75.
Models: PX-50XM3A
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct
the interference at his own expense.
Models: PX-50XM3A/S
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician
for help.
NOTE:
When you connect a computer to this monitor, use an RGB
cable including the ferrite core on both ends of the cable.
And regarding DVI and power cable, attach the supplied
ferrite cores. If you do not do this, this monitor will not
conform to mandatory FCC standards.
Attaching the ferrite cores:
Set the ferrite cores on both ends of the DVI cable (not
supplied), and both ends of the power cable (supplied).
Close the lid tightly until the clamps click.
Use the band to fasten the ferrite core (supplied) to the
DVI cable.
DVI cable (not supplied)
core (small)
core (small)
Connector
band
band
Power cable (supplied)
core (large)
core (large)
Important Information
Caution
50XM3A/S is for use only with following option units. Use
with other optional units is capable of resulting in instability
causing possible.
Manufacturer’s name: NEC Plasma Display Corporation
Stand: PX-ST1U, PX-ST1U/S, PX-50XM1U-ST
Wall Mount Unit: PX-W2U, PX-W3U
Vertical Wall Mount Unit: PX-42VP1U-VW
Tilt Mount Unit: PX-T2U, PX-T3U
Ceiling Mount Unit: PX-C2U, PX-C3U
Pole Unit: PX-42M3U-P
Vertical Pole Mount Unit: PX-42M3U-P-V
Horizontal Pole Mount Unit: PX-42M3U-P-H
Slant Stand: PX-50VP1U-PS
Multi Screen Mount Unit: PX-42VP1U-MW
Multi Screen Support Unit: PX-42VP1U-MW-S
