33
3. Projector Adjustment and Connecting
Focus
NOTE:
• For lens unit NP-9LS08ZM1, both central and peripheral focus must be adjusted. Use th/−buttons to adjust the central
focus.
1. Press the FOCUS +/− button.
• On the remote control, while pressing on the CTL button, press on VOL/FOCUS (+) or (−) button.
The focus is adjusted.
TIP: To obtain the best focus, perform the following (for fixed installation)
Preparation: Warm up the projector for one hour.
1. Use the FOCUS +/− buttons to make sure you obtain the best focus. If you do not, move the projector back and forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (
→
page
)
• You can also use the TEST button on the remote control to display the test pattern.
3. Keep pressing the FOCUS − button until the grid of the text pattern is made invisible.
4. Keep pressing the FOCUS + button until you obtain the best focus.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
NP-9LS08ZM1 Focus adjustment of the lens unit
The NP-9LS08ZM1 unit adjusts the focus around and on the center of the screen.
NOTE:
The image plane adjustment mechanism is locked with screws when shipped from the factory.
The image plane adjustment mechanism is not used normally. Use it when the level cannot be satisfied with just the focus adjust-
ment.
Adjustment method
1 Press the FOCUS +/– button to adjust the focus on the center of the
screen.
Press the VOL./FOCUS +/– button while pressing down the CTL button
when operating with the remote control.
