8
123456
123456
123456
123456
123456
123456
123456
PROJECTION CONFIGURATION CHANGE
.
Before Installation Change
The projector is electrically and mechanically set for 100 inch diagonal screen, front throw ceiling mount and a projection angle of
12 degrees. If your application is different from the factory setting(for example, ceiling to floor and screen size between 60 and 300
inch), you will have to reconfigure the projector for your application. Follow the change procedures according to the instructions
below.
To change screen size only :
1) Set the focus ring to the proper position.
For 60" screen size
R –––A-2, B-2
G –––A-1, B-2
B –––A-2, B-2
For 200-300" screen size
R –––A-5, B-5
G –––A-1, B-5
B –––A-5, B-5
2) Adujust the angle of the CRT's.
For 60" screen size
Move the CRT to the 60 positon
For 200-300" screen size
Move the CRT to the 200 or 300 position
3) Adjust the decorative lens panel.
For 60" screen size
Adjust to match the 60 position
For 200-300" screen size
Adjust to match the 200 or 300 position
4) Degauss the projector. See “Degaussing” on page 64 in the set-up manual.
To change to the desk top system (front)
1) Reverse the scan.
H –––1-Red, 2-Blue
V –––1-Brown, 2-Yellow
A –––1-Blue, 2-Red
B –––1-Brown, 2-Yellow
2) Set the focus ring to the proper position.
For 60" screen size
R –––A-2, B-2
G –––A-1, B-2
B –––A-2, B-2
For 200-300" screen size
R –––A-5, B-5
G –––A-1, B-5
B –––A-5, B-5
3) Adujust the angle of the CRT's.
For 60" screen size
Move the CRT to the 60 positon
For 200-300" screen size
Move the CRT to the 200 or 300 position
4) Adjust the decorative lens panel.
For 60" screen size
Adjust to match the 60 position
For 200-300" screen size
Adjust to match the 200 or 300 position
5) Degauss the projector. Select installation type from ASTIG OUTPUT.
See “ASTIG OUTPUT” on page 62 in the set-up manual.
