NEC PA622U, Руководство пользователя, Страница: 24 / 293

10
1. Introduction
Terminals
2 3 1 12 8
9
10 11
7
4
5 15 16 13 14 6
10
1. HDMI 1 IN Connector (Type A)
(
→
page 158 , 160 , 164 )
2. HDMI 2 IN Connector (Type A)
(
→
page 158 , 160 , 164 )
3. DisplayPort IN Connector
(
→
page 158 )
4. BNC IN [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Connec -
tors (BNC × 5)
(
→
page 157 , 162 )
5. BNC (CV) Input Connector (BNC × 1)
(
→
page 162 )
6. BNC (Y/C) Input Connector (BNC × 2)
(
→
page 162 )
7. BNC AUDIO IN Mini Jack (Stereo Mini)
(
→
page 160 , 162 )
8. COMPUTER IN/ Component Input Connector
(Mini D-Sub 15 Pin)
(
→
page 157 , 163 )
9. COMPUTER AUDIO IN Mini Jack (Stereo Mini)
(
→
page 157 , 163 )
10. Ethernet/HDBaseT Port (RJ-45) [HDBaseT Mod -
els]
(
→
page 165 , 169 )
Ethernet Port (RJ-45) [MM Models]
(
→
page 169 )
11. USB-A Port (Type A)
(
→
page 225 )
(HDBaseT Models: For future expansion. This port
allows for power supply.)
12. HDMI OUT Connector (Type A)
(
→
page 161 )
13. AUDIO OUT Mini Jack (Stereo Mini)
(
→
page 161 )
14. 3D SYNC Connector (Mini DIN 4 Pin)
(
→
page 41 )
15. PC CONTROL Port (D-Sub 9 Pin)
(
→
page 269 )
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page
275 .
16. REMOTE Connector (Stereo Mini)
Use this connector for wired remote control of the
projector using the NEC remote control for PX750U/
PH1000U/PH1400U series.
Connect the projector and optional remote control
using a commercially available wired remote control
cable.
NOTE:
• When a remote control cable is connected to the REMOTE
connector, infrared remote control operations cannot be
performed.
• Both the composite video signal from each input connector
as the computer, BNC, and BNC (CV), and the S-video signal
from the BNC (Y/C) Input connector are not output from HDMI
OUT Connector of this projector.
[HDBaseT Models]
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
* Connection Terminal of
MM Models
The orientation of the
port is upside down.
* Connection Termi-
nal of HDBaseT
Models