Height Adjustment
Be sure to support the weight of the projector before adjusting the height. This is a recommended two-person
step.
M5 Allen Wrench
M8 x 12mm
Security Screw
M5 Security Wrench
M8 x 12mm
Security Screw
Step 1
. Loosen the two (2) M8 x 12mm security screws on the
extension neck with the supplied M5 Allen wrench.
Step 2
. Slide the adjustable suspension neck into the desired
position.
Step 3
. Re-tighten the two (2) M8 x 12mm security screws.
Do not release the projector until the M8
screws are completely tight. This is a
recommended two-person step.
Disconnecting the Collar Assembly
THE FOLLOWING STEPS MUST BE PERFORMED BY TWO PEOPLE.
Please refer to Page 5 for instructions (Safety Locking Tab Operation) on how to disengage the mounting plate
from the collar assembly.
Safety Cable Clamp
Use two hands to support projector while it is
being disconnected.
Step 1
. While an assistant holds the projector with two hands,
grasp the collar assembly and turn the collar clockwise.
This will separate the two units.
Step 2
. Once the collar assembly is separated, unclip the
safety cable clamp.
Step 3
. Place the projector on a soft flat surface.
Page - 10 -
Installation Manual
