NEC NEAX2400 ICS, Руководство по программированию

Страница: 99 / 1089

NEAX2400 IPX Feature Programming Manual
Page 56
NDA-24297, Issue 1
A-78 Automatic Number Identification (ANI)
A-78 Automatic Number Identification (ANI)
General Description
This feature automatically sends the Calling Subscriber's number to the called party after a response is received from
the distant office. This feature is used for outgoing CO calls (e.g., Enhanced 911 (E911) calls) or TIE Line calls using
DTMF signaling.
Operating Procedure
No manual operation is required. Automatic Number Identification (ANI) calls are placed using normal call
origination procedures.
Service Conditions
1. The ANI feature for Enhanced 911 (E911) outgoing connections is available to the following connections:
a.) call from a station by LCR, DTMF signaling.
b.) call from an Attendant Console by LCR, DTMF signaling.
2. ANI sending number by Enhanced 911 (E911)-ANI UNIFIED NUMBER OF DIGITS [E-18] is NXX-
XXXX, where:
NXX: determined for each system
XXXX: telephone number
3. Sending-digit patterns in Enhanced 911 (E911)-ANI UNIFIED NUMBER OF DIGITS [E-18]:
a.) Outgoing call from a station:
• If ANI data is assigned:
KP-0-NXX-XXXX-ST
• If ANI data is not assigned:
KP-2-ST
b.) Outgoing call from ATTENDANT CONSOLE [A-3]:
• Individual ATTENDANT CONSOLE [A-3] access available and ANI data is assigned:
KP-0-NXX-XXXX-ST
• Individual Attendant Console access not available and ANI data is assigned:
KP-0-NXX-XXXX-ST
• ANND data is not assigned or is invalid:
KP-1-ST
4. An independent route is required for an Enhanced 911 (E911)-ANI interface.
5. It takes some time for a speech path to be established after a calling subscriber number has been sent out
to the remote office through the Enhanced 911 (E911)-ANI interface.
6. A Direct Distance Dialed (DDD) seizure tone is not sent after the digits have been sent out.
Telephone number
Information digit
Information digit
Individual Attendant Console
Information digit
ANI sending number
Information digit
Information digit