NEC N8146-74, Руководство пользователя

Страница: 21 / 32

21
3
．
Installing/Removing the Bezel to the Server
Take the steps below to install the bezel to the server.
●Read the sections "Safety Precautions" and "Handling precautions" in the User's Guide of
the server in which you are going to install the bezel to install or remove the bezel safely
and properly.
Note: The outer dimension of server is as follows after the bezel is installed.
98.0 mm (Width) × 415.7 mm (Depth) × 347.1 mm (Height)
(With air duct, stabilizers, and projection excluded)
200.0 mm (Width) × 447.5 mm (Depth) × 347.1 mm (Height)
(With air duct, stabilizers, and projection included)
1. Power off the server, and disconnect the power cord.
2. Lay down the server. Slide the side cover toward rear of the server (
①
in the figure)
while pushing the two eject buttons on the side cover, and lift the side cover
as shown
②
in figure , then remove the side cover.
Slide the side cover in the
direction shown by an arrow.
Eject Button
①
②
Lift the side cover as shown
in figure, then remove the
side cover.
③
Important