1.1)
Lay LCD on a mat as in Fig.1 (in order not to damage LCD).
1.2)
Remove STAND
(if used) and BEZEL
(Number of screws
that hold the STAND
is 2 pieces.
Number of screws
that hold the BEZEL
is 12 pieces.)
3.2)
Put protective glass on the panel.
NOTE
:
Align edge (refer to Fig. 3.4).
3.3)
Reinstall the BRACKET PWB IR and rear cover.
(Number of screws that hold the rear cover is 3 pieces.)
NOTE: Adjust the position of BRACKET PWB IR to the
lower hole.
Figure 3.1
Figure 3.2
Figure 3.3
Figure 3.5
Figure 3.4
Align edge
60mm
60mm
2.1)
Remove the part of the rear cover indicated in figure 2.1 and
the BRACKET PWB IR. (Number of the screws that hold the
rear cover is 3 pieces.)
3.1)
Paste TAPE-1 (DOUBLE sided ADHESIVE TAPE) and peel
the paper off. Specification of TAPE-1 should be equivalent
to "3M VHB tape 9473".
NOTE: 1. Do not paste TAPE-1 on panel's active area.
2. Do not paste TAPE-1 on the area in Fig. 3.2.
Figure 1
Figure 2.1
Figure 2.2
Adjust the position of BRACKET
PWB IR to the lower hole.
Remove BRACKET PWB IR
rear cover
Remove the three screws
Paste TAPE-1 on this area
Do not paste TAPE-1
on this area. This note
refers to all 4 corners.
BRACKET PWB IR
INSTALLATION MANUAL
PROTECTIVE GLASS
FOR MULTISYNC
®
LCD4020
,
LCD4620
AND
LCD5220
NECESSARY COMPONENTS:
- 1 piece protective glas (supplied)
- brackets (supplied) (40"-11pcs, 46"-13pcs, 52"-12 pcs)
- tape, "3M VHB tape 9473" or equivalent (not supplied)
- tape, "Scotchfoam 4718 3,2/12,7mm" or equivalent (not supplied)
Product used for demonstration in this manual: LCD4020
All manuals and user guides at all-guides.com
all-guides.com
