English-24
No Video
• If no video is present on the screen, turn the Power key off and on again.
• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).
• Some display cards do not output video signal when monitor is turned OFF/ON or disconnect/connect from the AC power
cord under low resolution with DisplayPort.
• When using an HDMI input, please change “OVER SCAN”.
No Sound
• Make sure the speaker cable is proper connected.
• Check to see if mute is activated.
• Check the volume in the OSD menu.
• Check selected OSD’s Tools to “SOUND INPUT”, when DisplayPort or HDMI is in use.
Brightness variations over time
• Change AUTO BRIGHTNESS to OFF and adjust brightness.
NOTE:
When AUTO BRIGHTNESS is set to ON, the monitor automatically adjusts brightness based on the environment.
When the brightness of surrounding environment changes, the monitor will also change.
•
Change DV MODE to STANDARD and adjust brightness.
NOTE:
When DV MODE is set to DYNAMIC, the monitor automatically adjusts brightness.
USB Hub does not operate
• Check to make sure the USB cord is properly connected. Refer to your USB device User’s Manual.
• Check if the USB upstream port on the monitor is connected to the USB downstream port on the computer. And make
sure the computer is ON.
Human sensor does not work
•
If human icon on SENSOR SETTING (HUMAN SENSING) is located on vermilion color, it is detected that there is
person.
• Make sure there is no object in front of Human sensor.
• Make sure there is no equipment which radiating infrared rays in front of monitor.
ControlSync does not work
• Check to make sure that ControlSync cable is connected correctly.
• Check to make sure that ControlSync cable is not in “loop” connection.
• Master monitor should be connected OUT connector only.
• Please use provided ControlSync cable.
• You can use up to 24 sub monitors via ControlSync.
No picture in multiple monitor connection
•
Check to make sure that the resolution has been lower than the recommended resolution setting.
•
Check to make sure that the display card supports MST (multi-stream transport).
•
The number of monitors daisy-chained through SST (single-stream transport) depends on HDCP contents limitation.
•
Monitors should be connected by the included DisplayPort cable.
•
Check to make sure that DP OUT MULTISTREAM is “AUTO” and BIT RATE setting is “HBR2” when using MST (multi-
stream transport) (see page 18).
Reproduced text looks blurred
•
Make sure that a supported resolution has been selected on the display card or system being used.
If in doubt, please refer to the user’s manual of the display card or system to change the resolution.