English-7
English
Figure C.1
* E233WM only.
Power cord
20° Tilt
DisplayPort
DVI
D-SUB
Highest
Stand
Position
Audio Input*
Audio Input*
Headphone*
To connect the LCD monitor to your system, follow these instructions:
NOTE:
Make sure to read “Recommended Use” (page 4) before installation.
1. Turn off the power of your computer.
2.
For a PC with DisplayPort output:
Connect the DisplayPort cable to the connector of the display card in your system
(
Figure A.1
).
For a PC or MAC with DVI digital output:
Connect the DVI signal cable to the connector of the display card in your system
(
Figure A.2
). Tighten all screws.
For a PC with Analog output:
Connect a 15-pin mini D-SUB signal cable to the connector of the display card in your
system (
Figure A.3
).
For a MAC with Thunderbolt output:
Connect a Mini DisplayPort to DisplayPort adapter (not included) to the computer,
then attached the included DisplayPort cable to the adapter and to the display (
Figure A.4
).
Figure A.1
Figure A.3
Figure A.2
Figure A.4
DisplayPort cable
DVI cable
Macintosh Cable Adapter (not included)
Macintosh Cable Adapter (not included)
NOTE:
1. When removing the DisplayPort cable, hold down the top button to release the lock.
2. Please use a DisplayPort Certifi ed DisplayPort cable.
3. Place hands on each side of the monitor to tilt the LCD panel 20-degree angle and lift up
to the highest position.
4. Connect all cables to the appropriate connectors (
Figure C.1
).
NOTE:
Incorrect cable connections may cause abnormal operation, damage display
quality/components of LCD module and/or shorten the module’s life.
Use an audio cable without a built-in resistor. Using an audio cable with
a built-in resistor turns down the sound*.
CAUTION:
To raise or lower screen, place a hand on each
side of the monitor and lift or lower to the desired
height. When you use handle to lower screen,
you might pinch your fi ngers.
